When installing carpet stair tread you’ll need some basic tools including tack strips, staples, knee kicker, stair tool, hammer, safety glasses, use knife, and measuring tape
There are two different ways you can go about installing carpet stair tread. These two strategies are called the waterfall method and the cap and band method. With the waterfall method one long pieces of carpet is used to cover every riser and tread. With a cap and band system one piece of carpet is installed over the tread called the cap and another piece, called the band, is used to cover the riser. The waterfall method is the hottest system used for installing carpet stair tread.
When installing carpet step tread you’ll need some basic tools including tack strips, staples, knee kicker, step tool, hammer, safety glasses, use knife, and measuring tape. Your initial step will be to remove any old carpet that might be covering the steps. The old tack strips and padding should also be removed.
Prior to beginning you will need to figure out how much carpet you will need. If you measure each tread and riser then add around three inches per stair. Then multiply that number by the amount of stairs that you have. If your steps have nosing you will have to add around one foot to your total.
Now you are prepared to install. Place a tack strip on the step crotch. Tuck the carpet into the crotch with your knee kicker. The knee kicker will be used to stretch the carpet from the center of the tread and hook it into the tack strip. Once it is firmly hooked in you can attach it lightly using your carpet tool to compress the tack strip pins. Trim excess pieces using your use knife. Make sure the carpet is smooth before continuing to the next tread. Do not forget to staple the carpet to the stair lip and tread each couple of inches. Continue this process until all of the steps are covered. Get carpet stair treads here.